Studiologic NUMA Organ Spécifications télécharger pdf (Page 20)

NUMA Organ by Studiologic®

20

Troubleshooting

Problem Possible cause Solution

NUMA Organ does not

turn on.

No power is supplied.

Defective power

cable. Fuse is blown

inside the NUMA

Organ.

Please make sure that

power is available and

switched on. Check

the power cable and

the internal fuse and

replace if needed, with

fuse as specied on

page 65.

NUMA Organ cannot be

controlled via MIDI.

MIDI data are not

being sent on MIDI

channel 1, 2 or 3.

Please send MIDI data

only on MIDI channel

1, 2 and/or 3.

No sound is heard. Fatar dynamic

TOUCH is activated.

All drawbars are

pushed all the way in.

Volume is set to 0.

Defective connecting

cable / headphone.

A sustain pedal is

connected to Expres-

sion pedal input.

Deactivate Fatar

dynamic TOUCH.

Pull at least one

drawbar down.

Set the Volume to a

higher level.

Change the cable /

headphone.

Unplug the sustain

pedal from Expression

pedal in.

Only one sound is

heard in split mode.

All drawbars of the

lower zone are

pushed all the way in.

Pull at least one draw-

bar down for the silent

zone.

No sound from the

audio input is heard.

Level of Audio In is

set to minimum.

External sound

device is not playing.

Defective cable

connection.

Adjust Stereo Audio In

Level.

Check if the exter-

nal sound device is

sending audio signal.

Change the

connection cable.

The Sustain pedal just

changes the Rotary

speed from Brake to

fast, but not Slow to

Fast.

The Modulation /

Rotary wheel is set to

Brake.

Set the position of the

Modulation / Rotary

wheel to Fast or Slow.

Please also refer to

page 12.

Sustain pedal does not

hold notes if pressed.

Fatar dynamic

TOUCH is deactiva-

ted.

Activate Fatar

dynamic TOUCH, if

you want to use the

foot switch as sustain

pedal. If Fatar dynamic

TOUCH is not

activated it will control

the Rotary speed.

Sustain pedal holds

notes if it is not pressed,

but cuts notes if

pressed.

The contact of the

attached sustain

pedal is closed at rest.

Plug in a sustain pedal

where contact is open

at rest.

Adjustments e.g. of the

drawbars cannot be

recorded with a

sequencer program.

Fatar dynamic

TOUCH is

deactivated.

The MIDI Input of

the sequencer is not

set to MIDI channels

1, 2 and 3 or to “all

inputs”.

Activate Fatar

dynamic TOUCH.

Set the input of the

sequencer to MIDI

channel 1, 2, 3 or to “all

inputs”.

Troubleshooting

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Commentaires sur ces manuels

Pas de commentaire